Makerspace: Soldering Station

Soldering is used to glue together electronics on a printed circuit board. The iron is heated up to the temperature where it can melt the solder. The heat gun is used for the surface mount components. 

Only solder in a well-ventilated with a fume extractor.

Always wear eye protection when using a soldering station.

Treat the soldering station with care as the solder wire can become extremely hot.

The Mixed-Signal Oscilloscope has the following features:

•    70MHz bandwidth selections 4 channels
•     Maximum real time sampling rate is 1GSa/s (4 channel models)
•     Per Channel 10M memory depth and VPO waveform display technology
•     Waveform update rate up to 120,000 wfms/s
•     8 “ WVGA TFT LCD display
•     Free Frequency Response Analyzer Software
•     Maximum 1M FFT provides higher frequency domain resolution measurements
•     High ,low and band pass filter functions
•     29,000 segmented memories and waveform search functions
•     I2C/SPI/UART/CAN/LIN serial bus trigger and decoding function
•     Data log function can track signal changes up to 1000 hours
•     Network storage function
•     Mask test function